Clarke 7640117, Инструкция по эксплуатации и техническому обслуживанию

Страница: 7 / 12

7
6. Place the upper handle onto the
top of the lower handle/axle
assembly as shown and use 1 long
bolt, 1 washer and 1 nut to lock it
into place.
7. Place a jubilee clip onto each
end of the hose.
8. Firmly push the end of the hose
onto the abrasive inlet on the
sandblasting gun.
9. Slide one of the jubilee clips so
that it is overlapping both the
hose and the abrasive inlet of the
sandblasting gun.
10. Tighten the jubilee clip with a
screwdriver.
11. Firmly push the opposite end of
the hose onto the abrasive outlet,
located at the base of the drum.
NOTE: there is an air hole in the
abrasive outlet - do not
cover this air hole with
abrasive hose.
12. Position the remaining jubilie clip
so that it is overlapping both the
hose and the abrasive outlet of
the drum.
13. Tighten the jubilee clip with a screwdriver.