12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4. Switch OFF by turning the rotary switch fully
anticlockwise, then move the Hi-Lo range lever to
the ‘H’ - high position, and repeat the process.
NOTE: In case of emergency, hit the switch cover
quickly. The cover will latch down and the
motor will be switched OFF.
The machine will not start when the emergency switch
cover is closed.
If the emergency switch is used to switch OFF, when the
rotary ON/OFF switch in the ON position, the machine
will not start again when the emergency switch is released. The amber
warning lamp will also illuminate.
The rotary switch must first be turned OFF then turned ON again to start the
machine.
Once the machine has been ‘run up’ check to ensure that it is secure on the
bench or board, and check again to ensure the post is secure by attempting
to tighten the post securing nut at the rear of the machine using the 36mm
spanner provided.
DRILLING
The machine is provided with a drill chuck and morse
taper shank - Fig.4.
1. Insert the taper shank up into the spindle, sharply.
CAUTION: TAKE EXTREME CARE NOT TO DAMAGE THE TAPER
IN ANY WAY. ANY BURR OR IRREGULARITY WILL RENDER IT
UNSERVICEABLE UNTIL IT IS PROPERLY REPAIRED USING A
GRIND STONE. PROFESSIONAL ADVICE SHOULD BE SOUGHT.
2. Pull off the spindle draw bolt cover from the head
(see Parts ID, Fig-C on page 10.) and insert the draw
bolt. Screw it into the end of the taper shank and
tighten using the spanner provided - see Fig.5
Содержание 7610860
Страница 28: ......
