9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING THE PUMP
1. Plug in the pump and switch on the power supply.
• The pump will begin to drain water.
2. Run the pump continuously or remove from the water and store in a frost
free location if the water is likely to freeze.
3. NEVER run the pump dry. Ensure the pump is switched off when water has
stopped flowing.
• The pump should be able to clear water down to a residual depth of the
inlet port, In this situation, air and residual water may be seen escaping
from the discharge hose.
4. Disconnect from the power supply when the water has been pumped out.
Avoid running the pump continuously if the discharge hose has become
obstructed and water is not flowing.
5. Disconnect the pump from the mains supply before placing it into or
removing it from the water.
6. NEVER insert your fingers into the pump whilst it is connected to the mains.
7. NEVER use the submersible pump in a swimming pool when there are
people or animals in the pool.
8. Keep the pump clear of any sediment by standing it on a platform or brick
or suspending it at a suitable depth.
9. DO NOT use the pump if the water is liable to freeze, as this can cause
damage to the pump. Remove the pump from the water and store it in a
frost free location.
WARNING: CHECK THE PUMP FOR DAMAGE BEFORE USE, DO NOT USE THE
PUMP IF IT IS DAMAGED IN ANY WAY.
Содержание 7230292
Страница 16: ......