11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING THE MACHINE FOR GRINDING
SETTING THE SPARK DEFLECTOR AND EYE SHIELD
1. Slacken the spark arrestor
securing screw and position the
arrester so that the bottom edge
is adjacent to the wheel with a
clearance of approximately
2 mm. Tighten the screw to secure
in position.
2. Set the plastic eye shield
mounting in position. It should be
tight enough so that it does not
move under operational
vibration, but loose enough so that it may easily be positioned by hand.
3. Check the grinding wheel guard and make any adjustments necessary
before use.
SETTING THE TOOLREST
1. Slacken the tool rest securing
knob and position the rest so that
it is adjacent to the grinding
wheel with a clearance of
approximately 2 mm. Tighten the
bolt to secure in position.
• NEVER attempt to grind a
piece of metal that is thinner
than the gap between the tool
rest and the grinding wheel.
WARNING: FRAGMENTS FROM A BROKEN/DETACHED GRINDING WHEEL
CAN CAUSE INJURY.
WARNING: ENSURE THAT THE WORKING POSITION ADOPTED DOES NOT
CAUSE OPERATOR FATIGUE WHICH MAY LEAD TO LOSS OF CONTROL OF
THE TOOL BEING GROUND.
WARNING: THE GRINDING WHEEL WILL CONTINUE TO ROTATE BRIEFLY
AFTER THE OFF SWITCH HAS BEEN PRESSED.
Содержание 6502130
Страница 24: ......
