13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
FITTING THE BOBBIN TO THE SANDER
1. If fitted, remove the fan and table
insert from the sander.
2. Clear the recess of any debris.
3. Slide the fan back on to the
spindle (vanes face down) and
engaged fully.
• The fan must be used at all
times.
4. Replace the table insert.
5. Slide the bobbin onto the spindle.
NOTE:
The smallest sanding sleeve
slides directly onto the spindle
shaft and not onto a drum.
6. Position the spacer ring in the
recess on the table insert.
• Use the smallest spacer ring
insert that will fit over the drum.
7. Install the correct washer.
• Use the largest washer that
does not overhang the sanding
sleeve.
8. Secure everything in place with
the spindle nut.
• A spindle nut wrench is
supplied.
NOTE:
As you tighten the spindle nut,
the drum expands outwards
slightly to hold the sanding sleeve secure.
WARNING: TO REDUCE THE RISK OF INJURY FROM ACCIDENTAL STARTING,
MAKE SURE THE SANDER IS UNPLUGGED BEFORE REMOVING OR
REPLACING THE SPACER RING INSERTS, SLEEVES AND DRUMS.