10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. Position the tool against the
surface to be hammered and pull
the trigger switch.
4. For continuous use, press the
trigger lock button after pressing
the trigger.
STOPPING WORK
1. Release the trigger or press the trigger if in continuous use mode and wait
until the chisel has stopped before placing the hammer on any surface.
HAMMERING TIPS
• Always use sharp, good quality hammer bits/chisels. The performance of
your hammer is dependant on the quality of the bits used.
• Reduce the pressure on the hammer bit when it is about to break
through. This will prevent the hammer from jamming.
• If hammering a large hole, first hammer a pilot hole using a smaller
hammer bit.
• Always apply pressure to your hammer bit in a straight line.
MAINTENANCE AND SERVICING
1. After use, remove the hammer bit and tap the side of the chuck to remove
any dust or chippings etc.
2. Keep the handle clean and free from oil and grease.
3. Worn or damaged parts must be replaced by qualified personnel.
4. Clean the tool regularly, use a soft brush and/or soft cleaning cloth. DO
NOT use any chemicals or harsh abrasives to clean the tool.
5. At the end of work, to prevent dust deposits you should use compressed air
(max.3 bar) to clean out the ventilation holes. When using compressed air
ALWAYS wear the correct PPE and eye protection.
Содержание 6479509
Страница 16: ......
