Clarke 6470098, Инструкция по эксплуатации и техническому обслуживанию

Страница: 6 / 20

6
DISC SAFETY INSTRUCTIONS
1. Disc speed. Check the speed of the disc before fitting to your angle grinder. Never
use a disc with a rpm speed less than the rpm speed of your angle grinder.
2. Inspect the disc before fitting. Never use a disc that is chipped, cracked or
damaged. Fragments from a broken or damaged disc can cause serious injury.
Make sure that defective discs are destroyed and not used.
3. Handling and mounting discs. Bonded abrasive products are breakable and shall
therefore be handled with utmost care. The use of damaged or improperly mounted
or used abrasive products is dangerous and can cause serious injuries.
4. Disc usage. Always refer to the label for specified usage and observe the safety
information. Do not use for purposes other than specified. Discs for wet cutting
applications must not be used with this angle grinder.
5. Use the correct disc. Always use the correct disc for it’s intended task. Using the
incorrect disc can cause serious injury.
6. Using the disc. Allow the disc and tool to do the work. Never force the disc onto the
workpiece as this could cause kickback and/or shatter the disc causing serious
injury. Kickback can occur in the event of a disc jam.
7. Cutting discs. Do not use cutting discs for side grinding. Do not put sideways pressure
on cutting discs.
8. Do not use reducing bushes. Do not use separate reducing bushes or adapters to
adapt large hole abrasive wheels. Do not force a disc onto a machine or alter the
size of the arbor hole.
9. Handling and storing discs. Abrasive products shall be handled and transported with
care. Abrasive products shall be stored in such a manner that they are not
subjected to mechanical damage and harmful environmental influences. It is
recommended that discs are stored in the case provided to protect them from
damage and hazardous material.