Clarke 6463060, Инструкция по эксплуатации

Страница: 8 / 12

8
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
7. When using the gun, observe the glue stick periodically through the
opening in the side of the gun, when the glue stick disappears, insert a new
stick to continue gluing.
8. Immediately the glue is applied, rest the gun back on its stand.
NOTE: The anti-drip feature of the nozzles is activated by releasing the
trigger, which will cut off the flow of glue into the nozzle. A small
amount of glue will remain in the tip when the trigger is released
and this will need to drain from the tip..
AFTER USE
1. After use, the glue gun must be placed on a stable surface, away from any
materials which could touch the hot nozzle.
2. When finished, unplug the gun, leave on stand and allow to cool down
before storing in its case.
CHANGING THE NOZZLES
The glue gun is supplied with 3 nozzles; two round nozzle (one installed) and a
flat nozzle.
1. To remove the nozzle from the
glue gun, start by removing the
silicon safety sleeve. Use a suitable
spanner to loosen and remove
the nozzle.
2. Screw the new nozzle into the tip
of the gun and tighten gently with
the spanner.
3. Replace the silicon safety sleeve
over the new nozzle.
• The glue gun is now ready for use.
CAUTION: DO NOT LEAVE THE GLUE GUN SWITCHED ON FOR MORE
THAN 15 MINUTES WITHOUT DISPENSING GLUE, FAILURE TO COMPLY WITH
THIS INSTRUCTION COULD RESULT IN THE GLUE STICK SOFTENING AND
LEAD TO THE GUN BECOMING INOPERATIVE.
WARNING: DISCONNECT FROM THE POWER SUPPLY AND ALLOW THE
TOOL TO COOL DOWN BEFORE ATTEMPTING TO CHANGE THE NOZZLE.