14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
WHAT TO DO IF THE SAW BLADE JAMS IN THE WORK PIECE
When withdrawing the work piece, the blade can bind in the kerf (cut). This is
usually caused by sawdust clogging the kerf or by the blade coming out of
the blade holders. If this happens:
1. Push the OFF button.
2. Wait until the saw has stopped and unplug it from the power source.
3. Remove the blade and the work piece.
4. Wedge the kerf open with a small flat screwdriver or wooden wedge then
remove the blade from the work piece.
ADJUSTMENTS
TILTING THE SAW TABLE
1. Loosen the table locking knob.
2. Set the table to the necessary
angle then tighten the table lock
knob to secure.
IMPORTANT: For accurate work you
must first do a trial cut and then re-
adjust the angle as necessary.
SQUARING THE SAW TABLE TO THE BLADE
1. Loosen the pressure plate
adjustment knob.
2. Raise the pressure plate and lock
it in the raised position.
WARNING: TO AVOID ACCIDENTAL STARTING WHICH COULD RESULT IN
SERIOUS INJURY, TURN THE SAW OFF, AND UNPLUG THE SAW FROM THE
POWER SOURCE.
