Clarke 6460200, Инструкция по эксплуатации и обслуживанию

Страница: 8 / 16

3. Fitting The Template Guide Bush
Fit the template guide, to the router base from
underneath, as shown in Fig.3, with the screws
used to secure the transparent plastic dust cover.
Replace the screws and tighten, taking care not
to overtighten.
NOTE: The Guide Bush allows the user to duplicate
a particular shape, that shape being used as a
template.
The template is fixed firmly to the workpiece and
the complete assembly fixed firmly to a
workbench. The Router is moved along the edge
of the template with the guide held carefully
Fig. 3
against its edge. Because the diameter of the guide is larger than the cutter, there will be
always be a certain offset to consider.
4. Fitting The Roller Guide
A Roller Guide is provided which replaces the
parallel Guide. This provides greater versatility,
allowing either straight line cuts, or contour cut-
ting to take place, depending upon the shape
of the template.
To assemble the guide, proceed as follows:
4.1 Remove the parallel fence by unscrewing
and pulling off the Microadjuster knob, as
illustrated in Fig.4.
Fig. 4
2. Fitting The Parallel Guide
2.1 Insert the rods into the guide body,
securing with the screws provided
2.2 Fit the assembled guide to the
router as shown in Fig. 3.
2.3 Secure using the locking screws
provided
NOTE: The parallel guide allows the user
to follow a straight edge with
accuracy.
It is always advisable to make a trial cut
in a piece similar to that to be worked
where possible.
Precise measurements are possible, using the microadjuster, indicated in Fig.2.
Fig. 2
Micro Adjuster
Locking Screw
8