15. Bolt the Dust Extractor Hose bracket to
the right hand rear of the table top, as
shown in Fig. 10, and attach the hose to
the upper blade guard at one end, and
the dust extractor outlet on the lower
blade guard at the other.
12
IMPORTANT: The Riving Kife must ALWAYS be in place and in good condition
Fig.9
Fig.10
14. Remove the Pivot bolt from the Upper
Blade Guard, then secure the Upper Blade
Guard to the Riving Knife using the same
bolt, screwed into the nut held in a recess
in the blade guard. The nut and end of
the bolt is arrowed in Fig.9.
WARNING!
The Upper Blade Guard must ALWAYS
be in place and in good condition. If it
is damaged in any way, have it
repaired or replaced.
G.Upper Blade Guard & Fittings
✗
✔
✗
Fig.8
IMPORTANT!
The Riving Knife MUST be completely in-line with the saw blade. Should it not be so, having followed these
assembly instructions, adjustments are necessary, which are described on page 19.
