D. Table Extension
7.
Lay the table extension face down and
adjoining the table top in the manner
shown in Fig. 5.
8.
Remove the two screws previously
entered to secure the leg to the table
top, then bolt the table extension to the
table top using the same nuts, washers
and screws, and a third screw for the
third mounting as shown.
9.
Attach the two Braces, one end to the
short leg brace, the other to the table
extension, noting that the angles formed
on the ends of the Braces are different
11
Fig.5
at each end. Ensure therefore that they lie in the correct plane at each end before securing
using the M6 nuts bolts and washers provided.
At this point, using assistance, turn the assembly on to its feet. Ensure you tighten the two lower
blade guard securing knobs, one of which is arrowed in Fig. 2, beforehand.
11. With the assembly resting firmly on its feet, shake it vigorously and once it is stable, proceed
to tighten all fixing nuts securely.
Ensure the table extension top and the table top lie in the same plane before securing the fixing
bolts.
F. The Riving Knife
12. Remove the Table insert, secured with 6
screws, then raise the saw blade fully, by
turning the handle on the end of the
lower blade guard box (see Fig.17, p 16).
13. Undo the clamping nut, arrowed in Fig.
7, sufficient for the riving knife to be
slipped between the two halves of the
clamp, with the curved slot of the riving
knife sliding over the clamping bolt.
Run up the clamping nut ensuring the
raised bosses on the inside faces of the
clamp halves are located in the curved
slot of the riving knife.
Before fully tightening the clamping nut, adjust the riving knife so that a gap of 3-8mm
maximum, exists between the knife and the tips of the saw blade teeth, for the full length of
the riving knife...see Fig 8, p. 12.
When satisfied, tighten the clamping nut and replace the Table Insert.
Fig.7
E. Dust Extraction Outlet
10. Attach the Dust Extraction Outlet to the
underside of the lower blade guard box,
as shown in Fig. 6.
Fig.6
