15
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7. Pull off the torch shroud with a
twisting movement, (if a tight fit,
some hand grips will be required)
then unscrew the contact tip.
8. Connect the welder to the power
supply and switch ON.
9. Set the ‘WIRE SPEED’ rotary control
on the front panel to position 4 or
6 and squeeze the trigger on the
torch body.
• The wire will feed through the
hose until it appears at the
torch tip.
• Ensuring the hose is free from
kinks during this process will
assist the wire in its passage
through the hose liner.
10. Release the trigger and switch off the welder and disconnect the machine
from the mains supply.
11. Refit the appropriate size contact tip (0.9 mm, for no gas welding is
supplied fitted) to suit your wire. then replace the shroud.
12. Trim the welding wire so that it protrudes no more than 5 mm from the end
of the contact tip.
Содержание 6015610
Страница 28: ......
