CLARKE Extractor Tools Operator's Manual
FORM NO. 79042A - 5
How To Operate The 8" and 12" Wands
NOTE:
Instructions for preparation and
operation of your extractor are given
with the extractor.
CAUTION:
Clarke will not be held liable for
damage to the carpet, or poor results
because of operator's lack of train-
ing.
CAUTION: Do not use water that is hotter
then 140°F.
To operate the 8" and 12" wands follow this proce-
dure:
1. Connect the vacuum hose to the hose con-
nector on the extractor and to the end of the
vacuum tube on the
fl
oor.
2. Connect the solution hose to the extractor
and the
fl
oor tool. To fasten the quick-dis-
connect slide the knurled collar on the female
coupling away from the opening. Push the
male coupling into the female coupling.
3. The switch that activates the motor for the
pump is on the extractor. Put the switch in
the "ON" position.
4. The switch that activates the motor for the
vacuum is on the extractor. Put the switch in
the "ON" position.
5. Move
the
fl
oor tool to the right-hand corner of
the carpet.
6. Hold
the
fl
oor tool at an angel that gives the
best seal between the tool to increase the
seal.
7. Press down on the tool to increase the seal.
8. Press the solution release lever.
9. Move backwards and pull the tool toward you
at a rate of about 30 feet per minute. Move
slower for very dirty areas.
10. Release the solution lever approximately six
inches before you stop moving backward.
11. Lift the wand and move it to the side of the
starting point.
12. To clean the edge of a room, move the wand
along the baseboard.