Clarke 4501135, Инструкция пользователя

Страница: 19 / 24

19
If more than one module is detected, you will be prompted to select
a module before the test.
. Control Module
Engine
Module $A4
Exit
Use the SCROLL button to select a module and press the
ENTER/EXIT button.
2) Wait a few seconds while the code reader validates the PID MAP.
. I/M Readiness
Reading PID.01
-Please Wait
-
3) If the vehicle supports both types of tests, then both types show on
the screen for selection
I/M Readiness
Since DTCs Cleared
This Drive Cycle
Exit
4) Use the SCROLL button to view the status of the
‘
MIL
’
light
(
“ON” or “OFF
) and the following monitors:
Misfire monitor
—Misfire monitor
Fuel System Mon --Fuel System Monitor
Comp. Component --Comprehensive Components Monitor
EGR --EGR System Monitor
Oxygen Sens Mon --O
2
Sensors Monitor
Catalyst Mon --Catalyst Monitor
EVAP System Mon --Evaporative System Monitor
Oxygen Sens Htr --O
2
Sensor Heater Monitor
Sec Air System -- Secondary Air Monitor
HTD --Heated Catalyst Monitor
A/C Refrig Mon --A/C System Monitor