Clarke 3503596, Руководство по сборке

Страница: 10 / 20

10
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
THE REAR END BOW
1. At the base of the rear End Bow, fit the End Bottom Rail (9) to the Corner
Foot (4). Attach Support Braces (10a+b) to the center of the last End Bow.
Use bolts (13), washer (17), and nuts (16). Repeat on the other side of the
End Bow. Do not completely tighten at this time because minor frame
adjustments will be done later.
2. At the base of the first Bow in from the end, attach End Bottom Rail (9) to
the base of Foot (5). Swing the end of the Support Braces (10a+b) over to
the connection of Foot (5) and the end of the Bottom Rail (8). The tapered
end of Bottom Rail (8) fits into End Bottom Rail (9). Use bolts (13), washers
(17), and nuts (16). Do not completely tighten at this time because minor
frame adjustments will be done later. Repeat these steps on the opposite
end of the End Bow. Continue assembling (8) between all of Middle Bows
until the final Middle Bow using the nuts and bolts (14) and (16). See Figure
4.
TOP RAILS
1. Start at one side of the rear End Bow along the curvature of the Roof Bend
(3). The End Top Rail (11) attaches to Roof Bend (3) on the inside of this