Clarke 3120132, Инструкция по эксплуатации и обслуживанию

Страница: 11 / 16

11
MAINTENANCE
WARNING! Make sure that the die grinder is disconnected from the air supply
before starting any cleaning or maintenance procedures.
DAILY
• Drain water from the compressor air
tank and air-line.
• Pour a few drops of CLARKE air line
oil, into the air inlet. This should be
carried out regardless of whether or
not an air line lubricator is used. If an
air-line lubricator is not used, this
procedure should be repeated after
every two to three hours of use.
WEEKLY
• Check the air inlet screen filter and
clean if necessary.
CLEANING
• Keep the body of the die grinder clean and free from debris, Grit or gum
deposits in the tool may reduce efficiency.
• After extensive use, remove the screen filter and flush out the grinder with
gum solvent oil or an equal mixture of SAE No10 oil and paraffin. Allow to
dry before use.
SERVICE AND REPAIR
• Major servicing and repair must be carried out by your local CLARKE
dealer.
AIRLINE PERFORMANCE
Please note that factors other than the tool may effect its operation and
efficiency such as reduced compressor output, excessive drain on the airline,
moisture or restrictions in the line, or the use of connectors of improper size or
poor condition which will reduce air supply.
**Clarke Air Line Oil is available from your CLARKE dealer part no. 3050825.
ACCESSORIES
A wide range of accessories are available including filter/regulators,
lubricators, high pressure hoses, etc. Contact your CLARKE dealer for further
information, or call CLARKE International on 01992 565333.
Air Inlet Screen
Filter (located
here)