Clarke 195TE, Руководство по эксплуатации и техническому обслуживанию

Страница: 22 / 31

22
1. Always weld clean, dry and well prepared material.
2. Hold gun at a 45 ° angle to the workpiece with nozzle about 6mm from the surface.
3. Move the gun smoothly and steadily as you weld.
4. Avoid welding in very draughty areas. A weak pitted and porous weld will result due
to air blowing away the protective welding gas.
5. Keep wire and wire liner clean. Do not use rusted wire.
6. Sharp bends or kinks on the welding hose should be avoided.
7. Always try to avoid getting particles of metal inside the machine since they could
cause short circuits.
8. If available, use compressed air to periodically clean the hose liner when changing
wire spools.
IMPORTANT: Disconnect from power source when carrying out this operation.
9. Using low pressure air (20-30 PSI), occasionally blow the dust from the inside of the
welder. This keeps the machine running cooler. Note: do not blow air over the printed
circuit board and electronic components.
10. The wire feed roller will eventually wear during normal use. With the correct tension
the pressure roller must feed the wire without slipping. If the pressure roller and the wire
feed roller make contact (when the wire is in place between them), the wire feed
roller must be replaced.
11. Check all cables periodically. They must be in good condition and not cracked.
WELDING TIPS AND MAINTENANCE
WIRE SIZE SPECIFICATION CHART
SWITCH
STEEL WIRE
DIAMETER
(mm)
WIRE SPEED
ADJUSTMENT
LOW
LOW
MEDIUM
MEDIUM
MEDIUM - HIGH
HIGH
0.6
0.6
0.6 - 0.8
0.6 - 0.8
0.8
0.8
1
2
3
4
5
6
SWITCH
POSITIONS
WARNING
(i) Make sure all flammable materials are removed from the work area.
(ii) Never look directly at the welding arc, it can seriously damage your eyes.
Always use an approved welding mask or helmet.
(iii) Wear protective clothing so that all skin areas are covered.
(iv) Keep a fire extinguisher handy.