Clarke 195TE, Руководство по эксплуатации и техническому обслуживанию

Страница: 16 / 31

16
1. The side panel is hinged at its rear edge: Open by pulling sideways at the front
edge, lay out all components contained within, and check to ensure that
they are all correct according to the list below.
A 2 Wheels
B 1 Axle
C 2 Wheel retaining washers
D 2 Casters
E 1 Handle
F 2 Brackets
G 4 Fixing screws
Loose Items - not shown
1 x Mask with fixing screws and washers
1 x Mask handle
2 x Handle retaining screws
1 x Transparent glass
1 x Dark glass
1 x 0.6mm welding tip
1 x 0.8mm welding tip
1 x 1.0mm welding tip
1 x Gas regulator
2 x Worm drive clips for gas hose connections (1 only for MIG 230TE)
1 x Welding torch and lead
1 x Plastic cover for hose support bracket (MIG195TE & 205TE only)
2 x Self tapping screws for cover (MIG195TE & 205TE only)
SHOULD ANY PART BE MISSING OR DAMAGED, CONTACT YOUR LOCAL
DEALER FOR REPLACEMENT.
2. Slot the axle (B) through the holes at the rear of the machine and slide a
wheel (A) on to each end followed by the retaining washers.
3. Screw the two casters (D) to the machine.
4. Slide handle (E) and the two brackets (F) into the top of the machine, line up
the holes with those in the casing, and secure using the 4 screws provided.
UNPACKING & PARTS IDENTIFICATION
Fig.1