9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PREPARATION FOR USE
UNPACKING
After removing the compressor from its packaging, check that it has not been
damaged in transit. Report any damage immediately to the dealer where the
item was purchased.
POSITIONING THE COMPRESSOR
1. Position the compressor near the point of work.
2. Avoid long air lines and extension cables if possible.
3. Make sure that the intake air is dry and dust free.
4.
DO NOT
use the compressor in a damp or wet room. The compressor should
only be used with good ventilation and an ambient temperature from
+5
o
C to 40
o
C). There must be no dust, acids, vapours, explosive gases or
flammable gases in the room.
5.
NEVER
use the compressor in areas where work is conducted with sprayed
water.
This compressor should be positioned on a stable, flat surface
.
If placed on a
shelf or raised off the ground, it should be secured appropriately to prevent it
from falling off during use.
6.
DO NOT
cover the compressor. Always position it with good all-round air
ventilation.
7. When moving the compressor;
•
ALWAYS
use the handle
•
DO NOT
lift by (or place a strain on) the airline fittings or hoses
•
ALWAYS
ensure it is switched off and disconnected from the power supply
CONNECTION AND START UP
1. Ensure the ON/OFF switch is in the OFF “O” position, then plug in the
compressor and switch ON at the mains supply.
WARNING: BEFORE USING THE COMPRESSOR, MAKE SURE THAT YOU
HAVE READ AND UNDERSTOOD THE SAFETY INSTRUCTIONS.
Содержание 1498500
Страница 20: ......
