Clarke 100EN, Руководство по эксплуатации и техническому обслуживанию

Страница: 11 / 33

11
ADDITIONAL SAFETY PRECAUTIONS for MIG WELDING
ALWAYS ensure that there is full free air circulating around the outer casing of
the machine, and that the louvres are unobstructed.
Welding arc can seriously damage your eyes. Both operator and spectators
must
ALWAYS use a proper welding face shield or helmet, with suitable filter
lenses. Proper gloves and working clothes should be worn at all times.
ALWAYS inspect the hose before use to ensure it is in good condition.
ALWAYS keep the free length of gas hose outside the work area.
ALWAYS remove all flammable materials from the welding area.
ALWAYS Keep fire extinguisher handy....’ Dry Powder, C0
2
or BCF, NOT Water
NEVER remove any of the panels unless the machine is disconnected from
the supply, AND never use the machine with any of the panels removed.
NEVER attempt any electrical or mechanical repair unless your are a qualified
technician. If you have a problem with the machine contact your local
CLARKE dealer.
NEVER use or store in a wet/damp environment. DO NOT EXPOSE TO RAIN.
NEVER continue to weld, if, at any time , you feel even the smallest electric shock.
Stop welding IMMEDIATELY, and DO NOT attempt to use the machine until the fault
is diagnosed and corrected.
NEVER point the MIG torch at any person or animal.
NEVER touch the MIG torch nozzle until the welder is switched OFF
and the nozzle has been allowed to cool off.
NEVER connect, disconnect, or attempt to service the MIG torch,
until the machine is switched OFF and disconnected from the mains
supply.
NEVER allow the cables to become wrapped around the operator or
any person in the vicinity.
If you convert your welder to operate with gas, observe the following
precautions
NEVER expose the gas cylinder to high temperatures
NEVER strike an arc near the gas cylinder
✔
✔
✔
✔
✔
✔
✗
✗
✗
✗
✗
✗
✗
✗
✗
✗