80
VX709E
English
INSTAL
LATIO
N
MAN
UAL
●
Connecting the parking brake cord
Connect the cord to parking brake lamp ground in the meter panel.
Note:
•
Connecting the parking brake cord to lamp ground allows you to watch video images when the parking brake
is engaged.
•
When the parking brake cord is not connected, the monitor will not display video images.
•
If “
AUDIO ONLY
” appears on the screen just after turning on the ACC power of the car, release the parking
brake while confirming safety, and then engage the parking brake again.
Connecting the Accessories
●
Connection to the Rear Vision Camera for vehicle
The Rear Vision Camera for vehicle can be connected to Rear Vision Camera terminal on the main
unit. For detailed information, refer to the instruction sheet or manual for the Rear Vision Camera.
Note:
•
Be sure to connect the reverse gear cord to the vehicle’s relevant terminal.
•
Connect the Rear Vision Camera to the RCA pin cord; if not, the screen turns black while the gearshift lever
is in the reverse gear position.
•
The power supply box CAA185 (sold separately) is required for connection of the main unit and the Rear
Vision Camera.
●
Navigation System
When using the NP509E:
Connect the CeNET Convert Box (CCB509) and the main unit via the CeNET and the RGB cables,
and then connect the CeNET Convert Box (CCB509) and the NP509E via the System cable.
When using the NAX983HD/NAX973HD/NAX963HD:
Connect the CeNET connector and the RGB terminal.
For detailed information, refer to the instruction manual of the Navigation System.
Parking brake lamp
+
cord to battery
Electro-tap
Parking brake
signal cord
Parking brake cord
(Grass-green)
●
How to attach the electro-tap
1. Place the Parking brake cord at the stopper,
and fold it back in the direction of the arrow.
2. Pass the Parking brake signal cord through,
and fold it back in the direction of the arrow.
Parking brake
Parking brake
signal cord
Parking brake
signal cord
Stopper
Parking brake cord
(Grass-green)