Clarion VRX925VD, Руководство по обслуживанию

Страница: 27 / 43

- 27 -
VRX925VD
REF No. PART No. DESCRIPTION REF No. PART No. DESCRIPTION REF No. PART No. DESCRIPTION
R515 119-1041-15 1/16W 100k ohm
R516 119-1031-15 1/16W 10k ohm
R517 119-1031-15 1/16W 10k ohm
R518 119-1031-15 1/16W 10k ohm
R519 119-1031-15 1/16W 10k ohm
R520 119-1031-15 1/16W 10k ohm
R521 119-1031-15 1/16W 10k ohm
R538 119-2201-15 1/16W 22 ohm
R539 119-8201-15 1/16W 82 ohm
R540 119-8201-15 1/16W 82 ohm
R541 119-8201-15 1/16W 82 ohm
R542 119-2201-15 1/16W 22 ohm
R543 119-8201-15 1/16W 82 ohm
R548 119-1041-15 1/16W 100k ohm
R549 119-1021-15 1/16W 1k ohm
R550 119-1041-15 1/16W 100k ohm
S201 013-7412-50 SPVG210100
X301 060-1524-90 22.57MHz
X401 060-1526-90 50.0MHz
X501 060-1525-90 25.0MHz
ATTENTION ABOUT THE SLIDE MECHANISM
In case that the LCD or the slide mechanism is replaced,the
position information of OPE/TILT/CLOSE must be re-
memorised in the EEP ROM on the Main PWB.
How to re-memorise
1. Prepare a plate (31.5mm) as follows and fix it on the pro-
jections of the LCD panel.
2. Push "ISR" key for more than 2 seconds pressing "MUTE"
key.
MUTE ISR
3. Release it after beep sounds.
4. To memorise the positions,OPEN/TILT-UP/TILT-DOWN/
CLOSE operations will be done automatically.
* The above procedure must be started from the "CLOSE"
position.
If the position is not complete "CLOSE",change the posi-
tion by the following procedure.
How to change the "CLOSE" position
A
B
The flexible PWB must be removed.
Move the position by adding 6 to 8volts to the motor.Manual
adjustment may cause a damage of the gears.The flexible PWB
must be removed from the Main PWB.
1. To open the mechanism,connect (A) to (-) and (B) to (+) on
the PWB of the slide mechanism.
2. To close the mechanism,connect (A) to (+) and (B) to (-).
CIRCUIT DIAGRAM
Inner switch PWB((B4) section
31.5mm