CLARION M10II TROUBLE SHOOTING
GETTING STARTED GUIDE
PAGE 28
6.
TROUBLE SHOOTING
PROBLEM
SOLUTION
RADIO does not show any indicator
lights.
Check the power connections. Wall plug,
chassis connection, and power switch(s)
that may be present at both the wall outlet
and at the unit.
RADIO still shows no indicator lights
Check power supply output, 6.2 Volts open
circuit and at least 5.9 Volts under 1.6A
load.
RADIO indicator lights show but cycle
on and off.
Cycling on and off could indicate a weak or
failing power supply. Check power supply
output, 6.2 Volts open circuit and at least
5.9 Volts under 1.6A load.
RADIO power light is on but no boot
lamp (TX) flashes.
NOTE: Boot lamp sequence is; POWER light (red) comes
on and stays on; RX light (green) comes on and goes off
after ~1 sec. After a few more seconds TX light, (red)
flashes five times, indicating Boot complete.
Check power supply, Run B10QUERY. If
unit fails to present status, check
AUI/MAU ETHERNET connection. Cycle
power, if still no status, call for technical
assistance.
During Test Procedure (Section 3)
RADIO power lights are on and boot
sequence was observed, but lights on
sending and receiving units are incorrect
Check B10MODE=on at both Radios, if
‘off’ it needs to be factory set to ‘on’.
Call
for technical assistance.
JX-4000F-WS must have ANT TYPE=0 if
“=1” it must be factory set to “0
”. Call for
technical assistance.
JX-4000F-WA, F-WC must have ANT
TYPE=1, if “=0” it must be factory set to
“1” and “ANTENNA SENSING TEST”
run.
Call for technical assistance, See
section 7.
RADIO power lights and boot sequence
are okay, but no throughput.
Check for correct CODE CHANNEL, and
SEARCH CODE. Both units must have
the same codes. If not, call for technical
assistance.
RADIO power lights and boot sequence
work but throughput low.
Run B10QUERY and check all parameters
for correct settings, see section 5.2
‘Configuration Parameters’. If not correct,
call for technical assistance.
