E
n
g
lis
h
EN-17
14.
INSTALLATION AND CONNECTION WIRE
Before
Starting
Battery
Figure
1
1.
This
set
is
exclusively
for
use
in
vessels
with
a negative ground 12V power supply.
2.
Read these instructions carefully.
3.
Be sure to disconnect the battery “ ”
terminal before starting. This is to
prevent short circuits during installation.
(Figure 1)
General Cautions
Installing the Unit
1.
Do not open the case. There are no
user serviceable parts inside. If you
drop anything into the unit during
installation, consult your dealer or an
authorized Clarion service center.
2.
Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner,
benzine, or alcohol etc.
For tough dirt, apply a little cold or
warm water to a soft cloth and wipe
off the dirt gently.
Bend the tabs of
the mounting sleeve
with a screwdriver or
similar utensil and
attach it in place.
Attach accessory to the unit.
NOTE:
Make sure that the unit is
install securely in place. If the unit is
unstable, it may malfunction.
Trim Ring Installing
2
2
