ERROR DISPLAY
If an error occurs, one of the following displays is displayed. Take the measures described below to eliminate the
problem.
Error Display
Cause
Measure
A DISC is loaded upside-down inside the CD deck and
does not play.
Eject the disc then reload it properly.
ER ROR 2
A CD inside the CD changer is not loaded.
This is a failure of CD changer’ s mechanism.
ER ROR 3
A CD inside the CD changer cannot be played due to
scratches, etc.
Replace with a non-scratched, non-warped disc.
ER ROR 6
A CD inside the CD changer cannot be played beca-
use it is loaded upside-down.
Eject the disc then reload it properly.
If an error display other than the ones described above appears, press the reset button.
A DISC is caught inside the CD deck and is not ejected. This is a failure of CD deck's mechanism.
ER ROR 2
ER ROR 3
A DISC cannot be played due to scratches, etc.
Replace with a non-scratched, non-warped-disc.
CD/MP3/
WMA
CD
changer
ER ROR 3
A DISC cannot be played due to scratches, etc.
Retry or replace with a non-scratched, non-warped
disc.
ER ROR 6
A DISC inside the DVD changer cannot be played be-
cause it is loaded upside-down.
Eject the disc then reload it properly.
ERROR P
Parental level error.
Set the correct Parental level.
ER ROR 2
A DISC inside the DVD changer cannot be played.
This is a failure of DVD mechanism.
Region code error.
Eject the disc and replace correct region code
disc.
DVD
changer
ER ROR R
Mode
ER ROR 6
FUSE
For other vehicles
For VW and Audi vehicles
(initial position)
Main unit side ISO connector
Figure 1
2. When the car stereo is installed in 1998 and later Volkswagen
models, make sure to cut the car lead wire connected the A-5
terminal. (A breakdown could occur if the lead wire is not cut.)
After cutting the lead wire, insulate the front end of the lead wire
with insulation tape to prevent the risk of short-circuits.
(Figure 2)
Note: Before cutting the lead wire, disconnect the car battery
- (negative) cable.
Figure 2
3. When the Main unit is also connected to an external amplifier,
connect REMOTE on the external amplifier to remote turn on
lead.
NOTES OF ISO CONNECTOR
1. For VW and Audi vehicles, change the position of fuse
installation as shown on the diagram.(Figure 1)
ISO CONNECTOR type
1. Press the [
ADJ
] button to switch to the adjustment selection
display.
2. Press the
lever upward or downward to select the
"SYS CHK <E>".
3. Press and hold the
button for 1 second or longer.
"SYSTEM CHK" appears in the display, then the unit returns
to the previous operation mode.
ANTI-THEFT INDICATOR
[
]
,
[
]
The red Anti-theft indicator is a function for preventing theft.
When the DCP is removed from the unit, this indicator blinks.
1. Press the [
ADJ
] button to switch to thead justment selection
display.
2. Press the
lever upward or downward to select the
"BLINK LED".
3. Turn the [
ROTARY
] knob to select "ON " or "OFF ".
[
]
,
Performing
a system check
DXZ558RMP
-3-
