English
10
5. OPERATIONS
Basic Operations
Note:
• Be sure to read this chapter referring to the
chapter “3. CONTROLS”
CAUTION
When the unit is turned on, starting and
stopping the engine with its volume
raised to the maximum level may harm
your hearings.
Be careful about adjusting the volume.
Power on / off
Notes:
• Start the engine before using this unit.
• Be careful about using this unit for a long
time without running the engine. If you
drain the car’s battery too far, you may not
be able to start the engine and this can
reduce the service life of the battery.
1. Start the engine. The power button / knob
illumination on the unit will light up.
Engine ON
position
2. Press the [ ] key on the front panel or
[
POWER
] key on the remote control to
turn on the power under standby mode.
The unit goes back to the last status after
power on.
3. Press and hold the [ ] key on the front
panel or press the [
POWER
] key on the
remote control to turn off the power under
work mode.
CT (Clock Time) display
• The displayed clock data is based on the
CT (clock time) data in the RDS signal.
Mute
Press the [
MUTE
] key on the remote control
to mute the volume from the unit.
Note
:
Doing the operation above again or adjusting
volume will release muting.
Volume adjustment
Turn the volume knob on the front panel or
press the [
,
] key on the remote control.
The adjustable range of volume is 0 to 40.
CAUTION
While driving, keep the volume level at
which external sounds can be heard.
Playing source selection
Press [
SRC
] key on the front panel and
remote control repeatedly to choose desired
playing source.
Notes:
1. Playing source selection means selecting
work mode, such as DISC mode, Radio
mode, Aux mode, etc.
2. When some devices are not ready, they
cannot be selected.
Display system time
Press the [
ADJ
] key on the front panel or
[
DISP
] key on the remote control to switch
the display information between RDS
information, system time and playing source.
