DOC ID - 1947
• Rev 02
3 / 4
Dimensions
(L × W × H)
Sensor
3.39
” L × 1.34” W × 0.7” H.
(86.1 ×34.03 × 17.78 mm)
Magnet
1” L × 7/8” W × 0.7” H.
(25.4 ×22.23 × 17.78 mm)
Water resistant
Yes
Certifications
FCC: 15.109 Class B 15.231, Industry
Canada: ICES-003, RSS-210
Regulatory information
Manufacturer
Clare Controls, Llc.
7519 Pennsylvania Ave, Suite 104
Sarasota, FL 34243
FCC compliance
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment
and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1)
this device may not cause interference, and
(2) this device must accept any
interference, including interference that may
cause undesired operation of the device.
Cet appareil est conforme avec Industrie
Canada exempts de licence standard RSS
(s). Son fonctionnement est soumis aux
deux conditions suivantes: (1) cet appareil
ne doit pas provoquer d'interférences et (2)
cet appareil doit accepter toute interférence,
y compris celles pouvant causer un
mauvais fonctionnement de l'appareil.
In accordance with FCC requirements of
human exposure to radio frequency fields,
the radiating element shall be installed such
that a minimum separation distance of 20
cm is maintained from the general
population.
FCC: 2ABBZ-RF-DWSOD-433
IC: 11817A-RFDWSOD433
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation. Changes or
modifications not expressly approved by the
party responsible for compliance could void
the user's authority to operate the
equipment.
This Class B digital apparatus complies with
Canadian ICES-3B.
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
MANUFACTURER HEREBY DISCLAIMS
ALL WARRANTIES AND
REPRESENTATIONS, WHETHER
EXPRESS, IMPLIED, STATUTORY OR
OTHERWISE INCLUDING (BUT NOT
LIMITED TO) ANY WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE WITH RESPECT
TO THESE PRODUCTS AND ANY
RELATED SOFTWARE.
MANUFACTURER FURTHER DISCLAIMS
ANY OTHER IMPLIED WARRANTY
UNDER THE UNIFORM COMPUTER
INFORMATION TRANSACTIONS ACT OR
SIMILAR LAW AS ENACTED BY ANY
STATE.
(USA only) SOME STATES DO NOT
ALLOW THE EXCLUSION OF IMPLIED
WARRANTIES, SO THE ABOVE
EXCLUSION MAY NOT APPLY TO YOU.
THIS WARRANTY GIVES YOU SPECIFIC
LEGAL RIGHTS AND YOU MAY ALSO
HAVE OTHER LEGAL RIGHTS THAT
VARY FROM STATE TO STATE.
MANUFACTURER MAKES NO
REPRESENTATION, WARRANTY,
COVENANT OR PROMISE THAT ITS
ALARM PRODUCTS AND/OR RELATED
SOFTWARE (I) WILL NOT BE HACKED,
COMPROMISED AND/OR
CIRCUMVENTED; (II) WILL PREVENT, OR
PROVIDE ADEQUATE WARNING OR
PROTECTION FROM, BREAK-INS,
BURGLARY, ROBBERY, FIRE; OR (III)
WILL WORK PROPERLY IN ALL
Environmental
class
UL: Indoor dry
IEC: 3K5