4 / 4
Doc ID - 724 • REV 07
Powering the CLIQ.lite
Plugging in the power adapter automatically turns on the
CLIQ.lite and starts the boot process.
To connect power to the CLIQ.lite:
1. Plug one end of the power adapter into a power receptacle
on the back of the CLIQ.lite labeled “12vdc.” See
Figure 3, item 9.
2. Check the LED on the front of the CLIQ.lite. It illuminates
purple when booting and blue when running normally. See
Figure 2, item 1.
Time, date, and time zone
Your CLIQ.lite controller automatically detects and sets its
time, date, and time zone when you connect it to your data
network. CLIQ.lite uses NTP and synchronizes the date and
time at boot up and periodically throughout the day.
Configure, test, and deploy a project
Refer to the Clare Controls Knowledge Base
instructions on creating, testing, and deploying a project. When
you deploy the project from Fusion, it will deploy to the
CLIQ.lite.
Adding the rubber foot covers
To prevent the unit from sliding, use the four rubber foot covers
included with your CLIQ.lite.
To add the rubber feet:
Peel each foot cover from the paper backing and place
one on each foot on the bottom of the CLIQ.lite.
Upgrading your CLIQ.lite license
With a simple license update, you can upgrade your CLIQ.lite
to have the same unlimited functions as a CLIQ.host. To
upgrade your license, contact our Technical Support group at
the numbers listed in the “Contact information” section. Before
calling, be sure you have the following information available.
License key number
UUID (listed on the bottom of the unit)
Dealer name and address
Regulatory information
Manufacturer
Clare Controls, Inc.
7519 Pennsylvania Ave, Suite 104
Sarasota, FL 34243
FCC compliance
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Specifications
Applications supported
Audio zones
4 zones
Audio streams
3
Lighting
10 circuits
Security
1 partition, 8 zones
Thermostats
2
Cameras
2
Pool spa
Not supported
Entertainment
4
I/O ports
RS-232 [1]
2
IR outputs
6 (2 pins per IR)
USB [2]
2
I/O
4 (8 pins)
CobraNet
1
Ethernet
1
Relay
6 pin, (2 normally open, 2 normally closed)
General
Processor
Freescale iMX6
Operating system
Linux
Memory
2 GB DRAM, 1 GB NAND Flash
Power
8.4 W (700 mA at 12 VDC)
Operating temperature
41 to 113°F (5 to 45°C)
Relative humidity
10 to 90%, non-condensing
Dimensions (W × H × D) 1.3 × 8 × 6 in. (3.3 × 20.32 × 15.24 cm)
[1] CLIQ.lite units support RS232 speeds of 300 baud and higher.
[2] CLIQ.lite units marked Rev C or higher use both USB ports. Units
marked Rev B or lower, or with a numerical revision level, are use the
top USB port only. See the label on the bottom of the unit to
determine its revision level.
Contact information
Clare Controls, Inc.
7519 Pennsylvania Ave, Suite 104
Sarasota, FL 34243
Support: 941.404.1072
Fax: 941.870.9646
http://support.clarecontrols.com
www.clarecontrols.com
