Doc ID - 724 • REV 07
3 / 4
Figure 4: Attaching the antenna to the CLIQ.lite
To attach the antenna using the extender cable:
1. Using a 17/64 in. drill bit, drill a hole in the sidewall of the
ClareHome Structured Enclosure Extender, near the
CLIQ.lite.
2. On the extender cable, remove the locknut and washer
from the SMA Male connector. See Figure 5.
3. Insert the threaded end though the hole, and then replace
the washer and locknut, tightening the locknut until the
connector is secure and does not wobble in the hole.
4. Screw the Z-Wave antenna to the connector until the
antenna is snug.
5. Attach the other end of the extender cable to the antenna
port on the rear of the CLIQ.lite. See Figure 3, item 8.
Figure 5: Attaching the antenna with the extender cable
(1) SMA Male connector
(2) Washer
(3) Locknut
RS-232 port pinouts
If you are using your own RJ12 cable (rather than the one
supplied), ensure your RJ12 cable connector pinouts match
the pinouts on the RS-232 ports shown in Figure 6.
Figure 6: RS-232 ports with pinouts
(1) (3)
(2)
RS232
#1
#2
