ClareVision Network Video Recorder Installation Guide
3
Hard disk installation
Disconnect the power from the NVR before installing a hard disk drive (HDD). A
factory-recommended HDD should be used for this installation.
Up to 16 SATA hard disks can be installed on your NVR.
Tools required: screwdriver.
To install the hard disk drive in the NVR:
1. Fasten the two hard disk mounting handles to the hard disk using a
screwdriver and the screws provided. Ensure the curved ends of the handles
are pointing inward and the hard drive label is facing up, as shown below.
Repeat this procedure for each hard drive you are installing.
2. Insert the key (provided), and then turn it clockwise to open the front panel
lock.
3. To open the front panel, press the two side buttons, and then pull the panel
forward and down.
