Page 6 of 25
User manual
Antenna model: AT3000
Rev 6.0 – September 2014
Clampco Sistemi is a registered trademark of
Calzavara SpA
– via Corecian, 60 – 33031 – Basiliano (Italy) http://www.clampco-sistemi.com/
1.2. Vertical antenna support (item SUPPORTOAT3000)
Firmly secure the base of the support to the ball joint on the tripod (Figure 2), use the ¼” brass threaded insert.
Connect the N male RF connector to the antenna port, then fix the axis selection connector of the composite cable
to the connector on the antenna pigtail. Be sure both connectors are well tightened to avoid poor contacts; after
measuring has been completed, check that the connectors are still tighten.
Insert the antenna handle into the support sleeve. Normally it is better to perform this operation while holding the
support base with one hand to prevent it from also rotating on the stand.
SUPPORTOAT3000
Threaded insert 1/4"
Composite cable
ATCFxx
WARNING!
The 7-pin connector for the
selection of the axis has a key
insertion and a red dot alignment.
To avoid damaging do not force or
over-rotate the male and female
connectors.
Align
Red dots!
Antenna
Side
(male)
Cable
Side
(female)
Figure 2
: Antenna fixing using the vertical support
Содержание AT3000
Страница 2: ......
