QTY. PART NO. DESCRIPTION
6
104926
RUNNER, .50 X 1.50 X 58 LG
1
104966
INSTRUCTION, RUNNER KIT, X200/X400
1
101550
KIT, HARDWARE RUNNER
(includes the following)
30
102516
SCREW,10-24 X 1" PTHMSSS
30
101548
NUT, 10-24 NYLOCK SS
30
101549
WASHER, #10 FENDER SS
Runner Kit Installation
1.
Position the strips on the base. Using a 3/1
6” or slightly larger drill bit, drill a hole through the base
using existing holes in the runner strip starting at the curved end of the base.
2.
Slightly tighten fasteners to hold the strip in place so that you may then bend the runner around the
curved area before drilling the next hole
(
If you have trouble bending the Wear Strip to the contour of the base, use a heat gun or hair dryer to
make the Strips more pliable before drilling.)
( Also, apply a small amount of grease to threads of screw to prevent seizing of threads.)
3.
Drill next hole through the base and slightly tighten fastener to hold the runner in place.
4.
Keep repeating this procedure for remaining holes and securely tighten all fasteners when they
are all installed.
5 .
Repeat same process for remaining runners.
PARTS LIST
START HERE
