P.12
P.13
4. Use
3.5 Initial start-up
Do not switch on the electric power at this time!
1. To purge the instantaneous water heater, open the hot water tap and wait until the water emerges free
of air bubbles.
2. In order to obtain an optimum water jet at low flow rates, screw the enclosed special tap aerator into
the tap outlet.
3. Switch on the electric power.
4. Adapt the water flow if necessary, if for example the temperature is not reached. The procedure is
described in the chapter “Use”.
5. Explain the functions and use of the instantaneous water heater to the user and hand over these
operating instructions to the user for information and future reference.
6. Register the appliance with the customer service department using the registration card or online at
www.germanpool.com.
3.Installation
As soon as the hot water tap is opened, the instantaneous water heater switches on automatically. Close the
tap and the appliance switches off automatically again.
4.1 Rating plate cover
On the inner part of the cover you can find the name of the application type (1), as well as the serial number
(2) and the article number (3).
4.1.1 Removing the cove
r
Under this cover, the rating plate and the hood screw are located.
1. Push the cover at the corrugation towards the wall bracket.
2. At the rear corners press the cover down until the front edge lifts.
3. Remove the cover by pulling forward.
1
2
AAAA
Gerät an Schutzleiter
anschließen!
Appliance must be earthed!
BBBB
CCCC
3
4.1.2 Replacing the cover
1. Push the cover flat towards the wall bracket under the edges of the water connections.
2. Press down the front edge of the cover and push it forward again at the rear edge until it fits.
