CLAGE
7
Repairs must only be carried out by
authorised professionals.
If a fault in your appliance cannot be
rectified with the aid of this table,
please contact the service organisa
tion of your importer or the Central
Customer Service Department. Please
have the details of the typeplate at
hand.
Problem
Cause
Solution
Water stays cold
Master fuse tripped
Renew or activate fuse
Flow rate of hot water too
weak
Outlet fitting dirty or calci-
fied
Clean shower head, jet
regulator or sieves
Fine filter dirty or calcified Clean fine filter
Selected temperature is
not reached
Excessive water flow
Reduce water flow rate at
the outlet
Selected temperature is
perceived to be too cold
Set temperature too low
Increase set temperature
by a specialist
Selected temperature is
perceived to be too hot
Set temperature too high
Decrease set temperature
by a specialist
4. Troubleshooting and service
This instantaneous water heater was manufactured conscientiously and checked sever-
al times before delivery. Should malfunctions nevertheless occur, it is usually only due
to a bagatelle. First attempt to switch the house fuses off and on again in order to reset
the electronics. Next, try to remedy the problem with reference to the following table.
In doing so, you will avoid unnecessary expense of customer service assistance.
CLAGE GmbH
After-Sales Service
Pirolweg 1 – 5
21337 Lüneburg
Germany
Phone: +49 4131 8901-40
Fax:
+49 4131 8901-41
Email: [email protected]
