9
Instructions for installer - CEX - 801045 - November 2018 v1.00 Art.no:
9120-25692
7. Installation
37
26
140
7
57
153
84
41
26
28
96
140
1. Thoroughly rinse the water supply pipes before installation to remove soiling from
the pipes.
2. Hold the appliance on the wall, and mark the drill lines at top and bottom, right and
left, corresponding to the small notches at the edge of the appliance hood (see bot-
tom figure). The alignment template (located on the pull-out pages in the middle of
this manual) may be used for this purpose alternatively.
3. Connect the top and bottom marks vertically with each other (A–A).
4. Connect the right and left marks horizontally with each other (B–B).
5. The intersections of these lines are the drill points.
6. Drill the holes using a 6 mm drill. Insert the included dowels and screws. The screws
have to protrude 5 mm.
7. Hang up the appliance into the rear hanging openings until it clicks into place.
Mounting the appliance
1. Attach the water connection pipes with to the appliance’s water connection. Use the
⅜ inch seals.
2. Open and close the hot water tap until no more air emerges from the pipe and all
air has been eliminated from the water heater.
Installing the appliance
