Hydro 4
Hydro 4
Page 8
PROGRAMMING WATERING - Test/manual watering. From the TEST page press .
Press to select which valve is to be activated, press to activate it for 5 minutes.
Press to change the manual watering run time (optional).
The symbol appears and flashes on the display together with the number of minutes of manual watering
remaining. The solenoid valve automatically closes and stops watering operations when the set watering minutes have
been reached. If you wish to stop watering operations in advance, press and the message OFF appears on the display.
PROGRAMMING WATERING - Exiting the test/manual watering page. Move to the page where TEST is displa-
yed with the symbols and flashing. Press to exit TEST/manual mode. Press to go back to the
page with the clock.
By entering TEST mode, any automatic watering is stopped but this will be restored on exit.
Reset. The factory settings can be restored by pressing and holding down and at the same time until
12:00 appears on the display (approx. 10 seconds). Then, completely reprogramme the water timer as described
in the programming sections.
Hydro 4 (cod.): 90829
Hydro 4 (cod.): 90829
OK
OK
EXIT
User manual
User manual
1
1
2
2
3
3
2
2
3
3
1
1
PROG
EXIT
LINE
PROG
EXIT
LINE
PROG
EXIT
LINE
PROG
EXIT
LINE
PROG
OK
OK
EXIT
S M T W T
F
S
S M T W T
F
S
S M T W T
F
S
