Claas LEXION 480, Руководство по ремонту

Страница: 91 / 1018

188 678.1 - RHB LEXION 480
2.2.17
Steering
Push the shaft (W) through the overrider switch (D)
and place the support washer (S) on the set collar (R)
of the overrider switch (D).
Continue sliding the shaft (W) through until the
overrider switch (D) makes contact with the set
collar (B). Secure the set collar (R) of the overrider
switch (D) on the shaft (W).
Check the axial play of the shaft (W). For this push the
Orbitrol firmly under the console (K).
The axial play should be approx. 1 mm , should this not
be the case, then readjust the quick-release
fastener (A).
(Fig. 33, 35)
Bolt the Orbitrol into place. Check the axial play of the
shaft (W) once more, and readjust it if necessary.
Push up the rubber cover (F) upwards.
Connect the cable (K) of the overrider switch (D) to the
existing wiring loom.
(Fig. 33, 36)
Refit the hydraulic lines back to the Orbitrol. Ensure
that absolutely no dirt enters the system.
(Fig. 37)
R
R
35
36
37