[SM‑276677‑A]
−
2
−
DESIGN AND SELECTION
１）Inferior quality air will deteriorate the product characteristics and affect its
durability badly. Use an air dryer, filter and sub micron filter to eliminate solid
material, moisture and tar and thus provide clean air from the pressure source.
In the case where the secondary side air pressure is reduced, the secondary side
air flows through the model ER３00 and will be discharged from the exhaust port.
The inside of the secondary piping and that of the load side should be kept clean.
Otherwise, similar conditions such as deteriorated product characteristics result.
２）The products response capability will be affected by the working pressure and load
volume. When a stable response is required, regulate the working pressure.
３）When the product is used with the secondary side being opened to the atmosphere
as in the case of air blowing, air pressure may vary depending on conditions of
piping and air blowing. In such a case, be sure to test the product under actual
using conditions or contact us in advance.
４）Select only the dryer, air filter, oil mist filter and regulator having the flow rate
higher than that used for PARECT units.
Recommended air circuit
Air filter
５μm
Regulator
Pressure
switch
Oil mist filter
Air dryer
Pneumatic
equipment
ＥＲ３００
Fig１
！
CAUTION
Discontinue
