[SM-206790-A/5]
―
21
―
INSTALLATION
４
3) Wiring of the small terminal box (B)
Wire the terminal box by following
①
to
⑥
in the illustration.
Direction of the case as
per illustrated above or
180
°
opposite.
Direction of the case 90
°
to the right or left off per
illustrated as above
Length
of
lead wire
8
13
4
Top rib
Case
Pin support
Live terminals
(Unnecessary to distinguish plus or minus)
①
Peeling a seal of lead wire
(Refer of the following table
as for the cutting length of cord.)
②
Terminal caulking
Crimp terminal (Parts No. 4K9-013)
Caulking tool (Tyco Electronics Japan 720781-3)
Earth terminal
Coil
Lead wire
(0.3 to 0.75mm
2
)
Cabtyre cord
JIS C3306VCTF 2-cord,
Outside diameter
φ
4 to 6.5
Cap
Washer
Gasket
Pin support
Case (Selective 4-position
in 90
°
apart available)
Gasket
Screw
④
Slide the gasket and pin support over
live terminals and earth terminal.
③
Insert caulked terminals
to the pin support
⑥
Tighten the cap after placing
a gasket and washer.
⑤
Place the case over the tip of pin support and
tighten the screw.
Note : Hook the top rib of pin support to the
hole edge of the case as per illustrated below.
Tightening torque
0.3
〜
0.4N
・
m
3
Tightening torque
1.65
〜
2.5N
・
m
