Page 5 of 9
Charging in The Charging Case
Multiverse Studio Kit 900MHz/2.4GHz utilizes a contactless charging system. Individual
chargers and USB cables are also included to enable charging individual units outside the
case.
Multiverse Studio Receivers have a run time of 20 hours using the default settings. The
setting which most influences run time is the backlight brightness. The default setting is 70%,
and run time can be extended by decreasing backlight brightness, or by setting a backlight
timeout period which will turn the backlight off after a time period you set. Touching any key
will turn the backlight on again for the period you chose. Setting the backlight to 100% will
reduce run time to approximately 16 hours.
Always charge with the lid of the case open for ventilation.
Charge time from fully
discharged to fully charged is 3.5 hours.
Charging may be done with Multiverse Studio Receivers either turned on or off.
To charge Multiverse Studio Receivers, plug the charging case into 100-240VAC power
using the included power cord with PowerCON True 1 connector. Simply lay the Multiverse
Studio Receivers onto the charging tray in their individual slots, making sure they are
touching the bottom of the tray. The charging indicator light will be red to indicate that
charging is in progress.
If the Multiverse Studio Receiver is on while charging, the battery icon on the user interface
will show a lightning bolt when touching the contactless charger, and the percentage of
charge will be shown. When fully charged to 100%, the charging indicator light will be green.
Charging Outside the Charging Case
Individual Multiverse Studio Receivers can be charged outside the charging case by using the
power supplies and USB-A to USB-C cables included in the kit. Plug the power supply into 100-
240VAC and plug the USB-A to USB-C cable into the power supply and the Multiverse Studio
Receiver. Using this method, charge time from fully discharged to fully charged is 2.5 hours.
