Page 3 of 9
Compliance
FCC Compliance Statement (United States)
This device complies with Part 15 of the Federal Communications Commission (FCC) Rules.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference.
2.
This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void
the user’s authority to operate this equipment.
IC Statement
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the
following two conditions:
1.
This device may not cause interference; and
2.
This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de lic
ence. L’exploitation est autorisée aux deux conditions suivantes:
1.
l’appareil ne doit pas produire de brouillage, et
2.
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouill
age est susceptible d’en compromettre le fonctionnement.
Conforms to UL STD. 508A Industrial Control Panel
Cert. to CAN STD C22.2 No.286-17
Safety Notices
Please read this entire manual before using your new equipment. Please keep the manual in a safe place
so you can refer to it in the future as required.
The Multiverse wireless DMX/RDM System is intended for use only by qualified professionals. Connection,
installation, and hanging of this equipment must be performed in accordance with all pertinent local,
regional, and national safety codes and regulations.
Do not operate in excessive heat/direct sunlight. Be sure installation provides adequate ventilation.
There are no user-serviceable parts inside! Refer to qualified service personnel!
RF Exposure:
The antenna(s) used for this transmitter must be installed to provide a separation distance of
at least 20cm from all persons and must not be collocated or operating in conjunction with any other
antenna or transmitter.
