Page 27 of 27
c. After you have connected to your Multiverse Transmitter, go to the main
DMXcat screen and tap the Multiverse Transmitter icon.
d. If not using the default universe numbers (1,2,3,4) input the desired universe
numbers into the Multiverse Transmitter and Multiverse Nodes.
e. Select an additional SHoW Key if desired and input it into the Multiverse
Transmitter and Multiverse Nodes
f.
Set any unused universes to “0” to disable broadcast of that universe’s DMX
slots.
g. If you add any Multiverse Nodes to your system that have not had their
universe configured, you can find them in the “Unconfigured” box on the main
Transmitter screen.
h. Test your system.
Troubleshooting
Table 4: Troubleshooting Guide
Symptom
Solution(s)
Unit does not power up.
Check that power cable is properly installed.
Test power outlet with another device.
Fixtures connected to the
receiver are not responding.
Check that the Tx and Rx symbols on transmitters and
receivers are solid.
Check that SHoW ID and SHoW Key match on
transmitters and receivers.
Check that Universe setting matches on Tx and Rx.