CITROËN ID 19, Руководство по ремонту, Страница: 24 / 482

ID 19 OPERATION No. ID 00 : Hydraulic system 22
TOOLS
b) Plastic pipes:
Protect ends with cellulose tape.
c) Rubber pipes:
Use cylindrical pegs 8 mm dia. x 50 mm long and 12 mm dia. x 50 mm long.
4 Protection of Hydraulic units after removal
Seal the openings of the units as dismantling proceeds (see PI.89):
a)
High pressure pump (see flg. I):
1 cap D.391-58 for the feed pipe.
1 ping D.391-88 for the high pressure outlet.
1 cap for the pusher and roller assembly.
b) Pressure regulator-accumulator assembly (see figs. 2 and 5):
1 cap D.391-60
for
the return pipe.
1 plug D.391-63 for union for the connection tube to distribution block.
1 plug D.391-88 for the intake union.
1 cap D.391-111 for the union on the accumulator control valve.
1 cap D.433-82 for the accumulator (pressure regulator disconnected).
c) Distribution block (see flg.3):
3 plugs D.391-63
d) Height corrector (see fig.4):
3 plugs D.391-63
1 plug D.435-91
e) Suspension cylinder (see figs .5 and 6):
1 cap D.433-82 for suspension sphere.
1 plug D.434-70 for connection on suspension for suspension sphere.
1 plug D.434-95 for inlet connection.
f) Master cylinder, 1st arrangement (see fig.7):
1 plug for feed connection.
2 plugs D. 391-63 for unions for connecting pipes to brakes.
g) Master cylinder, 2nd arrangement (see fig.8):
1 plug D.391-88 for feed connection.
3 plugs D.391-63 for high pressure inlet connection and unions for connecting pipes to brakes.
h) Front brake cylinders:
2 plugs D.391-63
i) Rear brake cylinder :
1 plug D.391-63
IMPORTANT NOTE - Plugs, caps and pegs must be thoroughly cleaned before using.