2 Network Settings and Operation
16
3-2. Using the Panel Button
The panel button on the operation panel is used to operate the Interface board.
Starting the LAN Interface Board
Turn on the printer. The Interface board starts working approximately 20 seconds after the printer
turns on.
Printing the Interface Board Configuration
Press the panel button. See 3-3, Printing the Interface Board Configuration (page 17) for details.
Switching to Setting Mode
Press and hold the panel button. The buzzer
*
will sound once, signaling a switch to setting mode.
・
Setting mode enables the reading of the factory default settings.
・
If there is no activity for three seconds in the setting mode, the buzzer
*
will sound once, signaling a
return to normal mode.
* Note that the buzzer will not sound if the Interface board is connected to the barcode printer. In
addition, the buzzer will not sound when the Interface board is used with the POS printer if the
buzzer has been set to not sound.
Restoring to the Factory Default Settings
Switch to setting mode, then press and hold the panel button. The Interface board will return to the
factory default settings.
When the operation is complete, the interface board will restart automatically.
The settings are cleared so the wireless LAN must be configured again.
When automatically obtaining the IP address from the DHCP server is set, an IP address that
differs from the previous one may be assigned.
Warning
