2 Preparation
22
2-7-2.
Example Settings
Use the WPS function and Configure Settings*
1) Connect the WLAN adapter to the IF1-WFXX.
2) Turn on the printer.
Confirm that the IF1-WFXX recognized the WLAN adapter. The WLAN adapter is recognized
approximately 20 seconds after the printer is turned on. The status indicator LED (green) starts flashing.
3) Hold the WPS button on the WLAN adapter for 1 second or more. The LED on the WLAN adapter starts
flashing.
If the adapter cover is being used, either open the cover or use a thin needle to press the WPS button
from the hole in the cover.
4) Start the WPS function of the access point.
*
5) When the configuration is complete, the LED of the WLAN adapter changes to transmission status.
You can confirm that the configuration was performed correctly by pressing the panel button to print
out the configuration of the IF1-WFXX. See 2-5, Printing the WLAN Interface Board Configuration (page
17) for details.
* For the method to start the WPS function, see the manual of the access point. If the access point you
are using does not support the WPS function, perform configuration by using the “
Configuring using
the Ethernet Adapter” method.
Configuring using the Ethernet Adapter
1) Connect the WLAN adapter to the IF1-WFXX.
2) Connect the Ethernet cable to the IF1-WFXX.
3) Turn on the printer.
After the printer is turned on and the IF1-WFXX starts, the IF1-WFXX will automatically obtain an IP
address from the DHCP server within 90 seconds. If an IP address cannot be obtained automatically, use
the ZeroConf function to allocate the IP address 169.254.XX.YY (XX.YY will differ by a setup
environment). Allocate the IP address while referring to 4-3, Setup Window (page 43).
4) Use the Web manager to configure the WLAN.
Configure the wireless LAN while referring to 3, Web Manager (page 23).
