Citizen iDP-460, Руководство пользователя

Страница: 52 / 75

iDP-460 User’s Manual
ESC d P-250, P-900R
[Name] Request Printer Status
[Code] <1B>H<64>H
[Function] In the P-250 mode and P-900R mode, this command sends the following 1-byte status
messages shown below. This command is valid only for the serial interface.
Value
Bit Code Function
0 1
0 L Paper end With paper Without paper
1 X Not defined
2 X Not defined
3 X Not defined
4 X Not defined
5 1 Unused - - Fixed at 1
6 F Mechanical error Without error With error
7 P Parity Fixed at 0 - -
[Caution] This command is ignored for the parallel interface and in the P-200 mode. If the paper
runs out or there is a mechanical error, the data may not be received.
[See Also] ESC a
ESC e (n) ; P-250, P-900R
[Name] Set Right Margin
[Code] <1B>H<65H>(n)<3B>H
[Domain] 0
≤
(n)
≤
42 (<30>H
≤
n
≤
<39>H)
[Function] In the P-250 mode and P-900R mode, this command controls whether the characters
should be printed or at which position of the line they should be printed, when the buffer
is full. When the parameter is set between 1 and 41, the printer will print automatically
when the n-th printable character is received. If the parameter is set beyond these limits,
printing will be performed when the LF command is received.
[Caution] Be sure to add ";"(<3B>H) to the end of the parameter. This command is ignored in other
than the P-250 mode and the P-900 mode.
[Initial Value] The characters are printed after the LF command is received in the
42-columns mode.