Checking the reference position
1.
Push the crown in to position
0
.
2.
Press and hold the upper right button
Ⓑ
for 10
seconds.
The hands and date
indication move to the
current reference positions
stored in memory.
Correct reference
positions:
All hands: 12 o'clock position
Date indication: midway
between “31” and “1”
When the current reference position is different from
the correct one, adjust the position following the steps of
“Correcting the reference position”.
3.
Press and release the upper right button
Ⓑ
to finish
checking.
Correcting the reference position
1.
Push the crown in to position
0
.
2.
Press and hold the upper right button
Ⓑ
for 10
seconds or more.
The hands and date indication move to the current reference
positions stored in memory.
3.
Pull the crown out to position
2
.
This will enable you to correct the reference position.
4.
Press and release the upper right button
Ⓑ
.
• Each time you press button
Ⓑ
, the target of adjustment
changes as follows and it moves slightly.
Chronograph 1/20 second hand
→
Chronograph
minute hand/date indication
→
Minute/hour/24-hour
hands
→
Second hand
→
(Back to the top)
5.
Rotate the crown to correct the reference position of
the active hand/indication.
• When you rotate the crown quickly, the hand will move
continuously. To stop the rapid movement, rotate the crown.
6.
Push the crown in to position
0
.
7.
Press and release the upper right button
Ⓑ
to finish
the procedure.
Resetting the watch — All Reset
1.
Pull the crown out to position
2
.
2.
Press and hold buttons
Ⓐ
and
Ⓑ
at the same time for
4 seconds or more and release them.
All reset is executed.
After All Reset
After All Reset, adjust the reference position. Execute the city
setting and receive signals manually (on-demand reception) to
adjust the time and calendar after that.
Using the chronograph
Measuring up to 60 minutes in 1/20 second increments.
• Chronograph stops when pulling out the crown during
measurement.
• Chronograph cannot be used when the power reserve is “nearly
empty”.
1.
Push the crown in to position
0
.
2.
Press and release the upper right button
Ⓑ
.
The chronograph minute, chronograph second and
chronograph 1/20 second hands point upright.
Start/stop:
press button
Ⓑ
.
• The chronograph 1/20 second hand will stop at the 0-second
position after 30 seconds since measurement started (or
restarted) but measurement continues.
Reset:
press button
Ⓐ
while the chronograph is stopped.
• Be sure to reset chronograph after finishing measurement.
To resume current time indication
Press button
Ⓐ
after resetting the chronograph.
• The hands automatically returns to indicate current time in 3
hours without executing any operation.
H80*
Abbreviated instruction
CITIZEN WATCH CO., LTD.
