Citizen CBM-820, Руководство пользователя

Страница: 85 / 144

– 70 –
GS I n
[Function] Sends Printer ID
[Code] ASCII GS I n
Hexadecimal 1D 49 n
Decimal 29 73 n
[Range] 1 n 3, 49 n 51
[Outline] This command sends the printer ID listed in the table below, depending on setting of n, when it
is executed.
[Caution] • If DTR/DSR control is selected and the memory switch 4-5 is set to 0, the printer sends only
1 byte after confirming that the host is ready to receive (the DSR signal status is Space).
If the host is not ready (the DSR signal status is Mark), the printer will wait until it will be
ready to receive. If XON/XOFF control is selected or the memory switch 4-5 is set to 1, the
printer will send only 1 byte without confirming the DSR signal status.
• Since this command is executed at deployment of the reception buffer, there may be a delay
between command reception and status sending, depending on the reception buffer
condition.
• If ASB is enabled by GS a, it is necessary to distinguish the status by this command from that
of ASB. See “6. Interface” for how to distinguish them.
• The ROM version may be changed.
• If n goes beyond the range, this command will be ignored.
[See Also] 5. Making DIP Switch Settings, 6. Interface
n Type of Printer ID Specification ID (Hex.)
1, 49 Model ID CBM-820 02H
2, 50 Type ID See Table below
3, 51 ROM version Depends on ROM version
**
n = 2 Type ID
Bit Description Hexadecimal Decimal
0 Unused 00 0
1 Unused 00 0
2 Undefined – –
3 Undefined – –
4 Unused 00 0
5 Undefined – –
6 Undefined – –
7 Unused 00 0