Citizen BD2-2220, Справочник по командам, Страница: 69 / 148

- 67 -
GS V m ........ (1)
GS V m n ..... (2)
[Function] Cutting the paper
[Code] (1) <1D>H<56>H<m>
(2) <1D>H<56>H<m><n>
[Range] (1) 0 ≤ m ≤ 1, 48 ≤ m ≤ 49
(2) m = 65,66
0 ≤ n ≤ 255
[Outline] Performs the specified paper cutting.
m Function
0, 48 Full cut
1, 49 Partial cut (Leaving a bridge area uncut)
65 Paper feed by “cut po {n x basic calculation pitch}” and full cut
66 Paper feed by “cut po {n x basic calculation pitch}” and partial cut
[Caution] • In STANDARD MODE, this command only works when it is entered at the beginning
of a line.
• Control to make the length of cut paper less than 10 mm is not executed.
For (1):
• Executes cutting of paper.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n ≠ 0, the paper is fed by
“n x basic calculation pitch” inches past the cut position, and then cut.
• The basic calculation pitch is set by GS P.
The paper feed amount is calculated with the vertical basic calculation pitch (y). A
fraction resulting from the calculation is corrected with the minimum pitch of the
mechanism, and the remainder is omitted.